When excluding (i.e. removing) a Decora Smart Z-Wave device from a Z-Wave network, it is best practice is to use the exclusion command found in the Z-Wave controller.
- Enter Programming Mode by holding the top of the paddle for 7 seconds (the Locator LED will turn amber), and then release (the Locator LED will begin to blink amber).
- Follow directions in the Z-Wave controller to enter exclusion mode.
- Tap the top of the paddle one time. The Locator LED will quickly flash green. The Z-Wave controller will exclude the Decora Smart device.
- The Z-Wave controller will confirm successful exclusion from the network.